The working principle of the purchase welding fume collector is to use the induced draft fan to transport air volume so that the dusty gas enters the box through the precipitator inlet, and the dusty gas is filtered through the filter bag through the gas shunt. The dust is left on the inner surface of the filter bag, and the purified gas enters the induced draft fan through the filter bag and is discharged by the exhaust pipe. After the dust collector works for a period of time, the dust on the filter bag gradually increases, resulting in the increase of the resistance of the filter bag, and the dust collector needs to be cleaned. After the dust removal is completed, the dust collector will work normally again. With the increase of the filter time, the residual adsorbed dust of the filter bag will increase more and more, which will affect the normal dust removal work. By using the shutdown and shaking vibration for tens of seconds, the residual dust attached to the internal surface of the filter bag will shake off, and the dust will fall into the ash bucket, drawer or directly onto the conveyor belt.

Below, take you to understand the design concept of purchase welding fume collector:

A, the use of the sleeve type polyester felt flat cloth bag, good service life.

Two, the application of computer aided design software, CNC machining equipment, mold production, to fit module structure, can be any combination of layers and column number.

3. Change the filter bag outside the inspection door in front of the modular flat bag dust collector to prevent dust from entering the clean air chamber, which is easy to operate and maintain.

Four, flexible inlet and outlet design, can achieve complex and changeable installation sites.

5. Modular flat bag dust collector filters dust above 0.003um, special configuration can meet the discharge requirements below 0.3mg/m3, and the noise of the dust collector is less than 80dB.

Vi. This modular flat bag dust collector is designed for submerged flow, which can reduce the influence of turbulence caused by dust and save electricity and energy.

The purchase welding fume collector should open the inspection door every week to check whether the dust removal cloth bag is normal and whether the surface area powder is too much, and find out the reason and troubleshoot the problem. If the fault is found, stop the machine in time, find out the reason, and then use it after repair. Equipment shall keep pulse controller surface clean. The pulse dust collector needs to add LC-250 high drop point synthetic grease to the bearing of the air pump once every 1000 hours, and replace the grease once a year. In the process of using the equipment, the air pump filter is cleaned once every half month to ensure that the gas path is smooth. The pulse dust collector often checks the grease in the fuel tank of the fan reduction motor and makes it up in time. Pulse dust collector checks the large film in the pulse valve once or twice a year, and the damaged and aging ones should be replaced in time.

fume cleaning period and fume cleaning time of purchase welding fume collector are important factors affecting the collection performance and operating status. The cleaning cycle and the cleaning time are related to the cleaning method and the nature of the object, so the corresponding dust properties and dust concentration should be understood, and the required examination should be carried out to determine. The principle of determining the cleaning cycle and the cleaning time is that different cleaning Settings are adopted according to different cleaning methods. The first thing to consider is that the next adhesion layer can be left on the filter bag, so as to determine the cleaning cycle with the correct cleaning time. The cleaning cycle is as long as possible, the cleaning time is as short as possible, so that it can operate under the resistance condition of economic dust removal equipment.

purchase welding fume collector https://www.kaisenfilter.com/KSJ-1-5B-Welding-Fume-Extractor.html